![]() ![]() Assisted Monitoring r equires a Ring Protect plan.If any of the sensors are tripped, the Base Station will set off the alarm siren and begin automatically calling you or your emergency contacts. Assisted Monitoring: Keeps an eye on all of the sensors in the home.Base Station: The Base Station is the heart of the system and is actively connected to and commands all of the Ring Alarm devices connected to the system.Set up one device at a time, and only pull its tab when the app prompts you. Your five or seven piece Ring Alarm Kit includes: Base Station, Keypad, Contact Sensor(s), Motion Detector(s) and a Range Extender. It’s just the physical entry of the PIN to change armed or disarmed state that I’m struggling with.Download the Ring Alarm (1st Generation) setup guide.ĭownload the Ring Alarm (2nd Generation) setup guide. I can even get the keypad to respond to different button presses from a ZEN32 scene controller so that’s awesome too. I confirmed that I’m using your driver so I’m good there. I can perform all of those functions from inside the app with no issues however. I enter the correct PIN and nothing happens on the keypad or in the app. The issue I’m having is that I can’t arm either stay or away modes or disarm those modes when entering the correct PIN. Once the keypad is armed, if I enter the incorrect PIN, I get the error tone and the keypad flashes (which is normal). Do you have PayPal, CashApp, Venmo, Zelle, or other way I can send you a few $$$? I know you’re doing this as a labor of love for the community, but I’d like to contribute a little something to your efforts. I recently moved to a different house which is wired with an old school security system so I plan on converting it to Konnected and that with the Ring Keypad (GEN2) should be incredible.įirstly, thank you again for your brilliant work on this project and also you’re responsiveness not only to me, but everyone on this thread. I stumbled upon this thread and realized someone finally did it! THANK YOU! Any ideas what I’m doing wrong?Īs previously mentioned, I’ve been a Ring user for years, but have always been curious about making a Ring Keypad (GEN2) work directly with ST independently of a ring account and base station. I did go into the device settings in the ST app and change my PIN from “0000” to my personal PIN, but still no love there. I can perform all of those functions from the ST app, but when I enter my pin on the keypad and then press a mode, I get no action. I’ve been using Ring for years, so I’m familiar with the arm/disarm process where you enter your PIN and press either STAY, AWAY, or DISARM. I followed the prompts on your channel invitation and successfully installed the driver (again?).ĭid the install via the channel invite write the correct 0x0301 value to the init and fingerprint files or do I have 2 versions of the same driver installed now? This is my first time working with Edge drivers so I continued reading and found the invitation to your channel for NA users. I changed those, but I don’t believe that impacted anything. Hello, I followed the tutorial to manually install the channel and driver and it wasn’t until after I installed it that I noticed the 0x0301 needed to be changed in the init and fingerprint files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |